How To Use Soft Shackles
Form a Loop in the Single Jib Sheet
I use a continuous jib sheet with two eye splices and one soft shackle. Go to ebay and type in 'soft shackle' and you will see some choices, (I like the robline ones), and various S&M bondage gear. Share this post. The array of soft shackle and jib sheets pulls across in front of a mast with little tendency to catch - reducing the need to place a crew member up on the foredeck. This version is easier to release than the more common Soft Shackle.
Jib sheets attach to the aft-most corner of the jib (the clew) and run back to the cockpit on both sides of the boat. The jib sheets are used to trim the sail in or ease it out. Consider using a soft shackle to tie your jib sheets to the sail.
On most sailboats, jib sheets are usually attached to the clew in one of two ways:
- When two individual sheets are used, both are often tied to the clew with a bowline. This knot can easily be untied when the sail is changed, but the two large bowlines form a big, heavy mass that can cause injury if it strikes you while wrestling with a flailing sail in the wind.
- When a single line is used, a metal shackle is often placed in a loop of the line at its center point, for shackling the lines to the clew. This also means a dangerous hard object that can injure a crew in the head or eye.
But There’s a Better Way
A better solution is to use a soft shackle made with the single jib sheet itself, whipping line, and a short, extra piece of line. This extra piece should be the same diameter as the sheet.
Here's How to Begin
First, form a loop at the center of the single line to be used as jib sheets. It should be about a foot in diameter. Whip the line firmly to maintain the loop.
Form Another Loop in a Short Piece of Line
With a second short piece of line, form another loop that passes through the jib sheet loop. Whip the ends together to maintain the loop.
Insert the Jib Sheet Loop Through the Clew
Insert the jib sheet loop through the sail’s clew.
Dyneema Shackle
Pass the Smaller Loop Through the Jib Sheet Loop
Finally, pass the ends of the smaller loop through the end of jib sheet loop, as shown. Then pull the jib sheet to cinch the knot tight.
Make A Soft Shackle
There are a few advantages of using a soft shackle. It’s lighter and less bulky (and therefore safer) than a metal shackle. It’s also easier to tie and untie with sail changes, and less expensive.